Quill Caliburn G

The Caliburn G coil gives your device a fresh start when the flavor fades or the vapor production weakens. We'll review its features, compatibility, and selection tips before you order it from Xvape.

Product Introduction

This coil, manufactured by Uwell, is a compression-fit coil that fits inside Caliburn refillable pods. It features a mesh tip that replaces the old coil without needing to change the pod itself, making it an economical option for everyday use.

It comes in a mesh version for slightly wider draws and another version designed for tighter draws, so you can choose the one that best suits your drawing style. Both deliver consistent performance if the liquid is suitable and not too thick.

It's also a well-known coil with readily available alternatives at e-cigarette stores, ensuring you have a replacement when you need one. Just make sure to choose a coil that suits your style and device.

What makes this coil special

This coil is a practical option for those who don't want complications. It's a small piece that can be changed in minutes and restores the device to its usual taste in most cases, as long as the liquid is clean and the device is in good condition.

• Simple to install, the coil fits into place by simply pressing.
• A distinct flavor thanks to the distributed mesh heating.
• The tight draw option is available for those who like it close to a traditional cigarette.
• The wider draw option is available for those who want more vapor.
• The Caliburn family is compatible with multiple devices, serving more than one device.
• Continuity of performance when replaced in a timely manner before it burns out.
• The choice between two versions is clear , as each resistance has a pulling characteristic that suits a different taste.

It can be said that the Caliburn G coil is one of the most requested spare parts among users of this family of devices, because it addresses the most common taste problems.

Compatibility and resistances

• 0.8 ohm resistor with mesh design.
• 1.0 ohm resistance designed for tight pulling.
• Works with Caliburn G, G2, Coco Prime and Explorer.
• It also works with GK2, GZ2, Tenet, Tenet Coco and Caliburn X.
• Compression fitting, and coils are usually sold in a pack of several pieces.
• The 0.8 ohm mesh version is suitable for those who like a slightly wider draw and clearer vapor.
• The 1.0 ohm version is suitable for a tight draw that resembles the usual cigarette-drawing style.

Thus, the Quill Caliburn G becomes a practical option for those who own one of the devices mentioned above and do not want to search for complicated parts or new pods.

Usage tips

To get the longest possible coil life, make sure the pod is clean before installation, and avoid operating it when the liquid in the pod is very low, as this is one of the reasons for the coil burning out prematurely.

• Start with a low power setting and gradually increase it until you find the right taste.
• Allow the new coil to soak in the liquid before operation.
• Avoid very thick liquids as they may slow absorption.
• Clean the pod before installing a new coil.
• If you experience a strange taste after installation, make sure the coil is properly compressed.
• Check your device model to ensure compatibility.
• Charge the device before the first trial to ensure that the taste problem is not due to the battery.

Warning: This product is intended for adults only (18 years and over) and should be kept away from children.

Order your Quilk now

Keep a spare coil so you don't suddenly run out of power. Order a Caliburn G coil from X-Vape and choose the resistance that suits you.